I have a couple of posts i want to make about issues in SDN - possibly quick fixes, but this topic is about an issue i can't seem to figure out. My setup EAP245V3 (x2) - Connected all under the same W

Hello all, I have the new SDN supported switch model and I have challenges when I am trying to use SFP ports. I am able to successfully use fiber SFP ports using Cisco and FS.com transceivers that I h

Hi I have an EAP245 and don't understand why the network speed seems low. The signal strength is good and the RX rate is 866Mbps yet activity speed never gets above 10MB/s. This seems a bit slow. I do

Hi, Perhaps an unusual question but how uni-directional or omni-directional are the EAP 245 WiFi access points? That is, how much is their broadcast range affected by their orientation? The reason why

Hello Folks, With really no directional / patch antennas availability from, TPlink, can following scenario work using EAP225 indoors version? 1. Mainly 5GHz design, and no DFS channels available to us

Folks, I want to have an email alert fired to me by SDN controller anytime an AP goes down and comes back online. So I set up SMTP and did a test thru built in method and I get this test email from co