I have the setup as specified in the picture below: As Soon as I connect Port 1 to the ISP I cannot manage the switch, the TP-link easy smart configuration tool does not even detect the witch. I used

I have fiber to the home. The ISP Ethernet carries IPTV on VLAN ID 4 and Internet. I configured the Switch as follows: Port 1 : VLAN ID 2 (untagged) Connected to : Internet Service Provider VLAN ID 4

Hi, I'm new to this forum but could not find whether this question has already been answered already. Sorry in case I missed it. Does the new EAP235-Wall wifi access point have IGMP snooping functiona

My EAP235-Wall is showing up as 100M and not 1000M as promised in the product specification. It's connected to a Cisco 3750G gigabit switch. Any settings that I must enable on the EAP235-Wall side to

Hello, I was wondering that I cannot see the users/clients connected via VPN, is it possible that this is not implemented ? My router is TL-R605. Also via VPN (L2TP in my example) is not implemented t

Hello After using the recent upgrade of Firmware 1.7.1 Build 20201016 Rel.62818 for my OC200 Controller in SDN encounter several issue, two of my EAP225 outdoor suddenly go to isolate mode and failed