Wi-Fi Routers
I have an Archer AX4400(US) Ver 2.6 router that is connected as an EasyMesh satellite to my primary router, an Archer BE550 (fw version 1.0.8 Build 20240226 rel.61914). This configuration has worked f
EasyMesh
0Helpful
36Views
I've bought an AX3000 recently in the hope that I might be able to mesh it with my existing C6, just so I could keep it as a "backup" but with better coordination on which devices connect to which. Se
OneMeshEasyMesh
2Helpful
39Views
Hello! I've just got a mesh system consisting of a BE800 main router, and AX55 and BE9300 satellites. Everything's running latest (beta for AX55) firmware with support for Ethernet backhaul, and satel
EasyMeshOneMesh
0Helpful
252Views
Spent $600 on two BE550's for my home. I have a router in my basement, and on the second story. These work great but lack advanced features needed to properly administer my home network. my previous r
Firmware UpdateFeature RequestEasyMeshAccess Control
1Helpful
60Views
Official ReleaseBE800 1.1.1 Update - Adding EasyMesh Wired and 6GHz Backhauls + Fixes For Reported Behaviors
BE800 Update - Adding EasyMesh Wired and 6GHz Backhauls + Fixes For Reported Behaviors Applicable Models: Archer BE800v1 and v1.6 Firmware Version: 1.1.1 Build 20240227 Recently, a new firmware was ma
Firmware UpdateEasyMeshOfficial
1Helpful
272Views
Now that Wired backhaul is supported with the latest BE800 release I have been able to successfully engage EasyMesh with my BE800 as the main router and a BE550 as the Satelite router. It does not see
EasyMeshIoT Networks
By
Jstewart0131
· Latest post a week ago
by terziyski
0Helpful
51Views
After switching mesh setting, the BE9300 5Ghz wifi got stuck in 100mbps mode. Even hard rebooting wont get out of it. The only way to break out of this was to turn off the 5Ghz > save > turn on 5GHz >
OneMeshEasyMeshFirmware Update100mbps stuck
0Helpful
103Views
When will the firmware update be released for EasyMesh on the AX75? I would like to use it as a second AP for my home network.
Firmware UpdateEasyMesh
0Helpful
98Views
I moved all my IoT/Smarthome devices to the IoT 2.4G network named IOT_PE_HOME on the BE800, I have 2 extenders, one RE650 in Mesh setup extends the MainHome 2.4/5G network and a RE300 to the upper fl
Access Point ModeEasyMeshOneMesh
By
mkostersitz
· Latest post 2024-03-08 19:48:28
by mkostersitz
0Helpful
131Views
Hello, I seem to be having the same issue as listed in this thread: https://community.tp-link.com/us/home/forum/topic/160665 Could you assist on the step by step process on how to Turn off the Mac Fil
EasyMeshFirmware UpdateWDS/Range Extender Mode
0Helpful
101Views