link aggregation
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I just bought an archer c4000, I have a 1008D switch I have had for about 1 year. I have been reading about Link Aggregation om my new router, and I was wondering if the throughput to my 1008D would increase if I connected it to an aggregated port?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Thanks for your reply. You just saved me a lot of dead-end trials.
Could you answer this for me? I picked the router up to move it to another location and heard a rattling inside the case. It sounds like a screw or nut that has come loose. Is it hard to open the case so I can find out what it is? I can't seem to find any case screws anywhere.
- Copy Link
- Report Inappropriate Content
Might possibly be a transister that broke off. There should not be any rattling that may be something to contact our support team about.
- Copy Link
- Report Inappropriate Content
But How about the AX3000/AX50 to use Lan3 & Lan4 connect to Managed Switch that support dynamic/static and Active/Passive modes. ?
Or, just can support Lan# & Lan4 to connect to NAS that support Link aggregation ?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1213
Replies: 4
Voters 0
No one has voted for it yet.