bricked router after wrong region firmware upgrade and reset button not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

bricked router after wrong region firmware upgrade and reset button not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
bricked router after wrong region firmware upgrade and reset button not working
bricked router after wrong region firmware upgrade and reset button not working
2020-04-08 02:09:21
Model: Archer D7  
Hardware Version: V1
Firmware Version: upgraded to (US) 150924 but I think this is (EU) router

Router refused to switch from DSL mode to Wireless Router mode, so I flashed new firmware from tp-link website, but instead of going from 150324 to 150514, I flashed 150924 (US) on this EU router (EU power block).Now there is no wired network light with cable plugged in. Only power light is on. Reset button completely unresponsive even 30 30 30. Tried to flash original firmware with TFTP but no joy. Still no network light and reset button does nothing and cannot communicate with router on 192.168.1.1 or 192.168.0.1. Thanks.

  0      
  0      
#1
Options
2 Reply
Re:bricked router after wrong region firmware upgrade and reset button not working
2020-04-08 18:31:24 - last edited 2020-04-08 22:38:16

@RobR 

 

We do not have a official firmware recovery method for that model unfortunately. Other users have mentioned using TFTP as a recvery method. If that is not working in your case the device may be bricked.

  0  
  0  
#2
Options
Re:bricked router after wrong region firmware upgrade and reset button not working
2020-04-08 19:30:40

@Tony 

Thanks. Hope there is a solution but expect I'm sol.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1089

Replies: 2