IPv6 doesn't work through AP300 in extender mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IPv6 doesn't work through AP300 in extender mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

t_wrex

2020-04-17 20:01:50

Posts: 9

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-04-17

IPv6 doesn't work through AP300 in extender mode

2020-04-17 20:01:50

Model: AP300

Hardware Version: V1

Firmware Version: 1.0.0 Build 20180907 Rel. 34397

I am using a TP-Link AP300 in repeater mode, repeating the signal from a Ubiquiti access point. The network has IPv6 provided by Comcast. IPv6 is working no problem when connected to the Ubiquiti, but not when connected to the TP-Link. IPv6 traffic is blocked entirely.

There are no settings related to IPv6 on the TP-Link interface.... does the device really not support IPv6?? Firmware is latest version 1.0.0 Build 20180907 Rel. 34397

1 Reply

Tony

2020-04-17 22:58:26

Posts: 6306

Helpful: 1479

Solutions: 165

Stories: 41

Registered: 2018-11-06

Re:IPv6 doesn't work through AP300 in extender mode

2020-04-17 22:58:26

@t_wrex

The user guide specs indicate that it only supports IPV4 so I do not believe it does support IPV6: https://static.tp-link.com/AP300(US)_V1_UG_1479805586914q.pdf

IPv6 doesn't work through AP300 in extender mode

IPv6 doesn't work through AP300 in extender mode

Information

Voters 0

Tags