Access Points

The Access Point products are mainly designed to establish a wireless network, and, with multiple working modes, you can also expand your existing wireless network or provide internet access to your wired only devices. In this section you can say hello to other members, ask, answer or discuss technical topics regarding Access Points.
Access Points

Tags

 
I have an AC1200 wired into my Ethernet and want it to act as a range extender so that everything is on the same wireless network vs having to switch between. What has to happen to do that?
Range Extender Mode
By Vjmcaneney · Latest post a week ago by terziyski
0Helpful
75Views
1Replies
I recently replaced my Nighthawk-turned-access point with a WA1201 in order to fix some packet loss issues. Sadly, the WA1201 brought issues of its own (it is in Access Point Mode). I'm noticing ping
0Helpful
43Views
0Replies
0Helpful
38Views
0Replies
What is the difference between EAP215 vs CPE510? I need to extend internet access from one building to another building about 300 feet away.
By vj987 · Latest post 2024-06-10 22:52:26 by Carl
0Helpful
94Views
1Replies
This is a generic question for the signal experts out there about ceiling mounted access points. I want to use a ceiling mounted AP at my house, and I narrowed it down to one of the entry level/small
By Gui_Lima · Latest post 2024-05-31 14:20:07 by Gui_Lima
3Helpful
237Views
2Replies
The EAP225-wall has the same TX power as the EAP655-wall and likely the same antenna pattern. Therefore so I expect it to not have better TX connection. However, are the RX electronics improved so tha
0Helpful
95Views
0Replies
I have 2 new out of the box EAP245 access points. They are a couple of years old, but just unboxed. I'm attempting to configure them to update the firmware and assign passwords, but can't seem to get
By Tex1301 · Latest post 2024-05-11 22:59:17 by terziyski
1Helpful
124Views
1Replies
Thanks in advance for any assistance anyone can offer. I have a hardwired backhaul network with four access points: TP-Link router (currently wifi off); two EAP-225 Outdoor WAPs and one EAP-110 Outdoo
By pscarbor · Latest post 2024-04-25 22:34:23 by pscarbor
0Helpful
336Views
7Replies
When I try to browse to my WAP, it usually times out. The IP Address is 10.1.1.4. I also have a TL-SG105E with an IP Address of 10.1.1.3. I'm able to get to the TL-SG105E just fine. I mention that as
By DonI49 · Latest post 2024-04-16 04:01:39 by terziyski
0Helpful
159Views
2Replies
EDIT: I rebuilt everything from the ground up and it's working fine now. Not sure what was causing it so I won't be able to tell you if you ask. My WAP is connected to a pfSense router. pfSense is con
Multi-SSID Mode
By DonI49 · Latest post 2024-04-14 13:43:06 by DonI49
2Helpful
292Views
2Replies
123...
123...