Home Network Community > Deco > Deco M5 in AP mode and second LAN port
< Deco

Deco M5 in AP mode and second LAN port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M5 in AP mode and second LAN port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M5 in AP mode and second LAN port
Deco M5 in AP mode and second LAN port
2020-08-15 21:52:06

Hello, I would like to connect 3 TP-LINK Deco M5 units with Ethernet cables (each will go directly to the existing router with a separate cable) and create a mesh network. Is it possible to use a second Ethernet port and connect a TV via it, for example, or can it only be used to connect another Deco unit?

  0      
 
  0      
 
#1
Options
2 Reply
Re:Deco M5 in AP mode and second LAN port
2020-08-16 03:52:03

@Nefer yes the second port can be used to connect a device. 

 

Ryan

  2  
  2  
#2
Options
Re:Deco M5 in AP mode and second LAN port
2020-08-17 22:39:29

@Nefer 

 

If you plan to have all nodes go to the router, make sure to set up the Deco with only one node wired to the router. Set up the Deco like a router, then switch the operating mode to AP Mode, after you will then be able to wire all nodes to the main router.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 943

Replies: 2

Related Articles
Cannot get port forwarding to work on Deco M5
4263 0
About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.