Home Network Community > Deco > Possible to have MoCa 2.0 or 2.5 on Deco M9 Plus?
< Deco

Possible to have MoCa 2.0 or 2.5 on Deco M9 Plus?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Possible to have MoCa 2.0 or 2.5 on Deco M9 Plus?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Possible to have MoCa 2.0 or 2.5 on Deco M9 Plus?
Possible to have MoCa 2.0 or 2.5 on Deco M9 Plus?
2020-10-18 01:35:32
Model: Deco M9 Plus  
Hardware Version:
Firmware Version:

Starting with Coax in, on Xfinity ISP, using my own non MoCa modem, and 1 of 3 Deco M9plus as the router.  Can this be used to run MoCa backhaul?  Does anyone know about using birectional splitters, Poe filters, and where those should go in the system?  Can this be setup in the interior of the house (ie living room), or does this need to be set up where it enters into the actual house, ie front bedroom closet?  Thank you in advance, as I am a technophobe/newbie in need of help!

  0      
 
  0      
 
#1
Options
1 Reply
Re:Possible to have MoCa 2.0 or 2.5 on Deco M9 Plus?
2020-10-20 17:28:53

@Jbird 

 

The Deco units utilize the IEEE 1905.1 protocol in order to communicate with each other via Ethernet. If the MoCa backhaul is not able to carry that over, then the Deco won't be able to utilize the Ethernet backhaul. This was an issue with some third party switches.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1055

Replies: 1

About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.