Archer AX10 Router not showing proper link type in admin client list nor showing any Tx/Rx rate

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer AX10 Router not showing proper link type in admin client list nor showing any Tx/Rx rate

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer AX10 Router not showing proper link type in admin client list nor showing any Tx/Rx rate
Archer AX10 Router not showing proper link type in admin client list nor showing any Tx/Rx rate
2020-11-04 03:40:15
Model: Archer AX10  
Hardware Version:
Firmware Version:

Seeing a problem with my new Archer AX10 for a single device connected via a TP-Link Wireless Extender (RE505X) configured as an Access Point that is using a MoCA (multi-media over coax Ethernet) connection as the high speed backhaul to the AX10 Router. 

There's two problems:
1) The admin network client screen wrongly shows the connected working device (a 2.4 Ghz Wyze security Cam)  as a LAN Ethernet connection but the device is connected via the extender/AP devices wireless 2.4 Ghz band.
2) The admin network client screen is also showing "--" for the Tx/Rx transmission rate (no data). 

The device is working fine and is network reachable. 

Looks like the firmware gets confused when devices are connected to extenders configured as Access Points and especially so when the AP is connected by Ethernet over MoCA connectivity rather than wireless-to-wireless.

As said, the connection works - just wrong administrative reporting on kind and no data transmission stats. 

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 392

Replies: 0