Mesh Deco x60 keep flashing yellow then red

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Mesh Deco x60 keep flashing yellow then red
Mesh Deco x60 keep flashing yellow then red
2021-01-16 05:15:36
Model: Deco X60
Hardware Version: V1
Firmware Version:

Hi, 

I have bought 2 sets of To link mesh Deco x60 each set have 3 satalites (total 6) .. among all the 6 there is one statalite have an issue .. when it's powered on its start with soled yellow .. the. It's flashes red .. then it's repeat .. tried to reset it .. connect connect it with eathernet to the main mesh .. tried to connect it hard wire via eathernet to my PC .. but PC cannot see that there is an eathernet device connected .. 

Have seen many reviews about conducting hard reset .. but cannot do any since the device is not seen by the pc .. 

 

Any help for me .. 

 

Regards, 

ALI

0
0
#1
Options
1 Reply
Re:Mesh Deco x60 keep flashing yellow then red
2021-01-18 22:46:53

@Q8IENG 

 

We do have a recovery procedure you can try that is mean for bricked units: https://www.tp-link.com/us/support/faq/2958/

 

If that fails I would reach out to support at that point.

0
0
#2
Options