Home Network Community > Wi-Fi Routers > Using AX3000 with Verizon FIOS
< Wi-Fi Routers

Using AX3000 with Verizon FIOS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Using AX3000 with Verizon FIOS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Using AX3000 with Verizon FIOS
Using AX3000 with Verizon FIOS
2021-01-18 13:53:19
Model: Archer AX3000  
Hardware Version:
Firmware Version:

I am trying to use my AX3000 to extend the wireless network at my home. I have Vierizon FIOS and TV service so it's my understanding that I can not simply replace the verizon modem/router because it's required for the TV boxes to work. I found a few articles online but I was hoping someone could help me out.

 

I was mainly going to follow the steps in this article https://www.dslreports.com/faq/12506 unless someone has another recommendation. I would like to avoid a double NAT.

 

I can not figure out how to do the following on th AX3000

 

  1. Set at static IP

  2. Disable DHCP

  3. I don't know if I need to hook up the ethernet cable to the WAN or LAN port

  4. How do enable AP mode?

 

 

  1      
 
  1      
 
#1
Options
1 Reply
Re:Using AX3000 with Verizon FIOS
2021-01-19 21:23:10

@Max2021 

 

There is an AP Mode inside of the router that makes configuring it easier. Here is a FAQ that shows how: https://www.tp-link.com/us/support/faq/2066/

  0  
  0  
#2
Options

Information

Helpful: 1

Views: 2627

Replies: 1

Related Articles
Using Archer C7 with Deco?
44 0
About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.