Just Installed TP Link AC1750 - need help with Nintendo Switch NAT

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Just Installed TP Link AC1750 - need help with Nintendo Switch NAT

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Just Installed TP Link AC1750 - need help with Nintendo Switch NAT
Just Installed TP Link AC1750 - need help with Nintendo Switch NAT
2021-03-14 17:41:13
Model: Archer A2  
Hardware Version: V7
Firmware Version:

I just purchased and installed the TP Link AC 1750 router (Archer A7) with Netgear LTE Modem and everything works fine, except our Nintendo switches.  The Nat type is D and it needs to be A, does anyone know how to change it?  I have looked everywhere and I can't find anything that has the same format that I have.  I need simplified instructions, if possible, please!

 

Thanks in advance!

 

  0      
  0      
#1
Options
1 Reply
Re:Just Installed TP Link AC1750 - need help with Nintendo Switch NAT
2021-03-16 20:18:31

@KristieM 

 

Here is an article from Nintendo with how to set up the device to forward the ports (this is to give NAT A): https://en-americas-support.nintendo.com/app/answers/detail/a_id/22272/~/how-to-set-up-a-routers-port-forwarding-for-a-nintendo-switch-console

 

Here is how you would port forward in the Archer A7 router: https://www.tp-link.com/us/support/faq/1541/

 

According to Nintendo, you would port forward the entire range of ports.

 

So you should have:

 

Service Type > Nintendo

External Port > 1-65535

Internal IP > whatever the IP of the switch is

Internal Port > leave blank or 1-65535

Protocol > UDP

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 2214

Replies: 1

Related Articles