Home Network Community > Deco > Unable to create Address Reservation with Deco X5700
< Deco

Unable to create Address Reservation with Deco X5700

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Unable to create Address Reservation with Deco X5700

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to create Address Reservation with Deco X5700
Unable to create Address Reservation with Deco X5700
2021-05-13 18:03:05
Model: Deco X90  
Hardware Version: V1
Firmware Version: 1.0.1 Build 20210207 Rel 52137

I have the Deco X5700 mesh routers and I have been trying to create an address reservation for a computer on my network.  It does not work.  When I go to Address Reservation then select the computer name from the list, then select "Done"  it fails and just says "Failed to save your settings. Please try again later".

I have tried rebooting the system but still the same results.

  0      
 
  0      
 
#1
Options
3 Reply
Re:Unable to create Address Reservation with Deco X5700
2021-05-19 15:18:38

@Eric0054 

 

The things I would probably try are:

 

-Use a different smart device

-Reboot just the main Deco

-Swap the main Deco with one of the satellite units

 

The configurations are handled from the main unit so something may be happening to it.

  0  
  0  
#2
Options
Re:Unable to create Address Reservation with Deco X5700
2021-08-01 12:13:19

@Eric0054 

 

Check your DHCP IP Range as if the IP is in the range of your DHCP then you can't reserve that IP.

  0  
  0  
#3
Options
Re:Unable to create Address Reservation with Deco X5700
2021-08-01 23:47:10

My experience creating address reservations is the opposite of that. My DHCP is set to 192.168.x.100 to 192.168.x.199 and I wanted to reserve 192.168.x.12 for a device. The Deco (M9 Plus) refuses saying that the address is not valid. So I have to change the DHCP to a range that includes the address I'm reserving (like 192.168.x.5 to 192.168.x.199) and then I can successfully reserve the address I want. Afterwards I restore the original DHCP limits and the reservation is not affected.

  3  
  3  
#4
Options

Information

Helpful: 0

Views: 1145

Replies: 3

About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.