Using 2 ISPs with Deco X60
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi there
I have two ISPs and I use a Deco X60 mesh system.
I would like to connect both my ISP routers to the two Ethernet ports on the main Deco unit
Is this configuration supported? or is one of the ports an output?
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@eguy2000 I would have to look into it, but I know that for instance the router that I have, the TP Link ER605, has a USB port that I think can be used as a back up for a wireless gateway. I believe the term is called failover. It will automatically switch to a cellular based Internet when the land based cable Internet goes out. I think it can be done to have a 4G LTE or 5G modem as a back up ISP but it has to be done through USB port on a router that supports it. I do not think that the Deco's when used as routers support this. You would need a different kind of router and just use the Deco's as access points.
I believe it can definitely be done, but you need the proper modem and a router. I don't think it should be done with the Decos alone.
- Copy Link
- Report Inappropriate Content
@eguy2000 both ports are bidirectional. how would two ISP's work if both give out an IP address? how would the router know which IP address to use?
- Copy Link
- Report Inappropriate Content
@dictoresno thanks for the response. You're right about the IP selection. I was hoping there would be a switch in the app to make that choice.
one of my ISP is a wireless provider with lower speed. I use it as a backup to my fiber internet. My fiber internet is down today so I had to manually switch the Ethernet cable to my second ISP.
Seems like this can't be done on the X60
thanke
- Copy Link
- Report Inappropriate Content
@eguy2000 I would have to look into it, but I know that for instance the router that I have, the TP Link ER605, has a USB port that I think can be used as a back up for a wireless gateway. I believe the term is called failover. It will automatically switch to a cellular based Internet when the land based cable Internet goes out. I think it can be done to have a 4G LTE or 5G modem as a back up ISP but it has to be done through USB port on a router that supports it. I do not think that the Deco's when used as routers support this. You would need a different kind of router and just use the Deco's as access points.
I believe it can definitely be done, but you need the proper modem and a router. I don't think it should be done with the Decos alone.
- Copy Link
- Report Inappropriate Content
Thanks for your help. We can close this discussion
- Copy Link
- Report Inappropriate Content
I just wanted to verify that what @dictoresno is the case
The deco does not support multiple ISPs and can only establish one connection for WAN access. You can, however, find a variety of switches that support the feature. However, these features will most likely fall under business-class switches and routers.
There are two methods for "combining" a connection: load balancing and failover.
Failover detects when the active WAN connection loses its signal, while load balancing will distribute your speeds across the two WAN connections.
Our team is not really clear on how these would affect a connection to your deco, but you may not necessarily need to use the Decos in AP mode, depending on the settings and features of the device placed in front that combines the two WAN connections. As this forum is intended for consumer products and applications, you may post to our SMB community for clarification on how these features work.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2013
Replies: 5
Voters 0
No one has voted for it yet.