AX3000 Pro in AP mode and DHCP disabled showing wired clients when no ports occupied

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX3000 Pro in AP mode and DHCP disabled showing wired clients when no ports occupied

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RickJamesBish

2023-05-26 21:48:49 - last edited 2023-05-26 22:08:59

Posts: 353

Helpful: 147

Solutions: 13

Stories: 1

Registered: 2022-09-24

AX3000 Pro in AP mode and DHCP disabled showing wired clients when no ports occupied

2023-05-26 21:48:49 - last edited 2023-05-26 22:08:59

Model: Archer AX3000

Hardware Version: V1

Firmware Version: 1.0.4

Connected a new AX3000 Pro in AP Model and DHCP disabled to my existing DHCP Ubiquiti Gateway. The AX3000 is showing 3 wireless clients, which is correct, however, it shows 15 wired clients. These clients IP addresses and Mac Addresses match up with DHCP clients of the Gateway. Why are they being shown as clients of the AX3000 when they are neither assigned and IP address by the AX3000 nor wired to or going through it?

1 Reply

jra11500

LV3

2023-06-09 09:18:11

Posts: 289

Helpful: 116

Solutions: 14

Stories: 2

Registered: 2022-12-20

Re:AX3000 Pro in AP mode and DHCP disabled showing wired clients when no ports occupied

2023-06-09 09:18:11

@RickJamesBish

Let me comment that I am using several AX3000 (AX55) routers, one in the AP mode. The AP router displays all clients in the network, not just those connected directly to it. I think it is due to the discovery protocols used by the device. Actually it is quite handy as I can see all connected clients and know exactly what's happening on the network.

AX3000 Pro in AP mode and DHCP disabled showing wired clients when no ports occupied

AX3000 Pro in AP mode and DHCP disabled showing wired clients when no ports occupied

Information

Voters 0

Tags