AX3000 Whitelist doesn't work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX3000 Whitelist doesn't work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AX3000 Whitelist doesn't work
AX3000 Whitelist doesn't work
2023-12-22 13:55:59
Model: Archer AX3000  
Hardware Version: V1
Firmware Version: 1.0.6 Build 20230831 rel.67466(5553)

The whitelist doesn't seem to work at all. I can remove unwanted devices from the list, but when I click "Save", it simply puts all devices back into the list again. If I don't click save and only move the devices out of the list, they can still access the internet and all other network resources. There doesn't seem to be a way to actually prevent devices on the network from accessing the internet.

 

This is really disapointing as the whole reason I purchased the AX3000 is because of the parental controls and mac filtering.

 

Does anyone have any guidance? The instructions are very minimal, so there's not a lot to screw up.

  0      
  0      
#1
Options
1 Reply
Re:AX3000 Whitelist doesn't work
2023-12-22 23:18:01

  @GeraldRowe 

 

Here's the access control guide for configuring a whitelist.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options