Enable Wifi6E in mixed mesh network
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I have a mixed setup where the main Deco is an X50 POE and then 2 X75. They are all connected via ethernet.
I have noticed that with such configuration I am unable to set the Wifi Network 6E to be for network instead of just backhaul, and I suspect the reason is because the X50 does NOT support 6E. How can I still enable such feature for the other 2 decos?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Is it possible to set any Deco as Main unit, even though it is not the one connected directly to the modem?
- Copy Link
- Report Inappropriate Content
When in router mode main Deco should be connected directly to the modem - details.
When using ethernet backhaul you can refer this FAQ and read through this thread.
If Deco is about to be used in AP mode you can refer this FAQ
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If the Deco is in router mode this could work but you should not connect to this switch anything else since that may cause a network loops.
One more thing - don't use a D-Link switch for that since they are know to cause issues if used with Deco.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 311
Replies: 5
Voters 0
No one has voted for it yet.