Limited Bandwidth to clients

Limited Bandwidth to clients

Limited Bandwidth to clients
Limited Bandwidth to clients
11 hours ago
Model: Deco BE25  
Hardware Version: V1
Firmware Version: 1.1.3 Build 20251023 Rel. 40143

I have an AT&T BGW530-900 modem configured with a passthrough host to by Deco BE25 acting as the router.  About a week ago, I noticed some slow internet speeds from my laptop.  While I have 300 Mbps service, I normally only get around 200 to 250Mbps down, but my laptop was limited to around 30Mbps.  I tested other clients on my network including my phone, my hardwired iMac, etc.  Everything that I can run a speedtest on is limited to around 30Mbps.  I even connected my laptop directly to the BE25 with a network cable and had the same speed.

 

But if I do a speed test at my AT&T modem, I get 200Mbps.  If I do a speed test on the BE25, I get 200Mbps.  If I connect my laptop up to my AT&T modem, I get 200Mbps.  This has got me stumped.  I don't remember configuring anything different the past week.  I don't have QoS enabled.  Any ideas?

  0      
  0      
#1
Options
1 Reply
Re:Limited Bandwidth to clients
6 hours ago

  @mcmoyer 

 

See if the following post helps if not I will provide you with instructions on how to open up a ticket with support. 

 

https://community.tp-link.com/us/home/kb/detail/412864

 

Please visit both links in the "Recommended Troubleshooting" 

Need help with the Deco app, setup, Ethernet backhaul, network switch or rolling back firmware? Router or AP mode? https://community.tp-link.com/us/home/forum/topic/699816?page=1
  0  
  0  
#2
Options