Home Network Community > Wi-Fi Routers > Bridge Mode for Archer C5400
< Wi-Fi Routers

Bridge Mode for Archer C5400

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bridge Mode for Archer C5400

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bridge Mode for Archer C5400
Bridge Mode for Archer C5400
2017-02-17 08:16:30
Model :

Hardware Version :

Firmware Version :

ISP :

Region - USA

Model - Archer C5400 V2

Firmware - Most current as of Jan 16, 2017

Can anyone please tell me how to set IPV4 to bridge (pass through) mode? I see the option on IPV6, but not on IPV4. I must use my cable modem as the router and DHCP so need C5400 in bridge mode because I have devices connected to the cable modem gigabit ports that need to communicate the wireless devices connected to the C5400 (e.g. avoid double NAT).

Thanks
  0      
 
  0      
 
#1
Options
2 Reply
Re:Bridge Mode for Archer C5400
2017-02-17 08:55:30
According to your demand, it's recommended to set up the Archer C5400 router as an access point.
Here is the FAQ link for how to:
http://www.tp-link.com/en/faq-1199.html
  0  
  0  
#2
Options
Re:Bridge Mode for Archer C5400
2017-02-18 01:59:16
Thank you. I was able to enable AP mode. I would suggest a simple bridge mode option in a future firmware update.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 4199

Replies: 2

About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.