Logging in always defaults to Quick Setup
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Logging in always defaults to Quick Setup
Model :
Hardware Version :
Firmware Version :
ISP :
Hardware: ArcherC9 v3.0
Firmware: 1.3.1 Build 20171215 rel.35219(5553)
Is it normal for the TP-Link admin interface to always default to Quick Setup after logging in? I always click on the basic or advanced tab immediately depending on what I need to do, but it's a bit confusing to see the first time setup pop up every time I load the settings page.
Hardware Version :
Firmware Version :
ISP :
Hardware: ArcherC9 v3.0
Firmware: 1.3.1 Build 20171215 rel.35219(5553)
Is it normal for the TP-Link admin interface to always default to Quick Setup after logging in? I always click on the basic or advanced tab immediately depending on what I need to do, but it's a bit confusing to see the first time setup pop up every time I load the settings page.