Home Network Community > All Threads > A7 Setup for Wireless Bridge Failing Me
< All Threads

A7 Setup for Wireless Bridge Failing Me

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

A7 Setup for Wireless Bridge Failing Me

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
A7 Setup for Wireless Bridge Failing Me
A7 Setup for Wireless Bridge Failing Me
2020-02-25 18:15:55
Model: Archer A7  
Hardware Version: V5
Firmware Version: Latest

Not sure where to post my question so here goes- I'm tring to setup an A7 Router to be a wireless bridge to a single device on Ethernetwithout success. I found the instructions in the A7 User Manuall for wireless bridge setup and followed them and the trobleshooting tips but can't get the setup to work. One thing that is painfully obvious is when looking at the Status panel after completeing setup and troubleshooting options the Wireless network name is NOT being set.

 

I've tried several things to get this to work but so far no luck. Can anyone give some pointerss on how to get this working?

 

Thank you in advance.

 

David Sadler

  0      
 
  0      
 
#1
Options
2 Reply
Re:A7 Setup for Wireless Bridge Failing Me
2020-02-26 18:37:50

@OldSneezer 

 

Hi David,

 

So you are trying to set the Archer A7 to repeat the wireless signal of a host router is that correct?

Check out the Latest: Recent Smart Home Features and Updates for Tapo and Kasa Securing Your TP-Link ID with 2FA:Deco and Tether | Smart Home Splash into a Smarter Summer with Sub-G Sensors, Matter, and Apple Home!
  0  
  0  
#2
Options
Re:A7 Setup for Wireless Bridge Failing Me
2020-02-26 20:53:22

@Carl -

 

Thank you for responding. Not exactly. I'm trying to setup the router tobe a wireless to LAN bridge as described in the Archer C7 User Guide on page 100. My router is an Archer A7 but it says this User guides applies to the A7 as well.. So this means Wireless Riuter )))->  A7 Router LAN-> device.

 

As I said, once I'm done the Status Panel Wireless status shows rhe Network name unchanged after I have used the System Parameters WDS setup to set wirelss name and password. I can't get the setup to join my Wireless network (HouseontheHill). After several attempts I haven't been able to get the A7 to show the network name.

 

Can you help? Thank you

  1  
  1  
#3
Options

Information

Helpful: 0

Views: 1926

Replies: 2

Related Articles
Is it possible to setup an Archer A7 to load balance between a wifi bridge and WAN connection?
611 0
Wireless bridge
1040 0
AX11000 Wireless Bridge
226 0
Internet via wireless failing
635 0
Wireless failing/unable to login
489 0
Archer A7 email log setup fails
515 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.