Installation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Installation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Installation
Installation
2020-06-05 06:32:10
Model: Deco M9 Plus  
Hardware Version:
Firmware Version:

I installed 2decos, needed to relocate one, now LED is blinking blue.How can i get it to go green like it was before relocation?

  0      
  0      
#1
Options
1 Reply
Re:Installation
2020-06-05 17:53:19

@Rochitas 

 

Take the Deco unit back to the same room of the main Deco and plug it un to see if it does go green. If so, you may need to put the problem Deco closer to either the other slave Deco or the main Deco.

 

If the Deco is in the same room as the main Deco, and it blinks blue, default it by holding the reset for 2 seconds. The LED should go yellow, then it will start pulsing blue. Add the Deco back in with the app.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 368

Replies: 1

Related Articles