Could not add Second Deco at 1st floor

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Could not add Second Deco at 1st floor

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Could not add Second Deco at 1st floor
Could not add Second Deco at 1st floor
2021-01-12 05:23:02
Model: Deco M4  
Hardware Version:
Firmware Version: 1.4.3

I have another issue with Tp-link Deco M4
the past week I only use one unit (living room)


1) yesterday when I set up the second unit at 1st floor (main bedroom) 
it couldn't found any my main deco (ground floor - living room)

 


2) after following the suggestion from tp guide, I put the second deco at  my main deco (ground floor - living room)
The connection was successful and manage to add my second deco.
 


So i plug out my second deco and put it back at 1st floor (main bedroom), now my led turn into [COLOR=red]BLINKING RED[/COLOR]. As per TP-link deco suggestion, they ask me to reset. But then it loops back to my point number 1.

 

 

Before this, by only using main deco (living room) -  I still manage to get internet connection if I'm staying at 1st floor (main bedroom)


Any suggestion?


 

  0      
  0      
#1
Options
1 Reply
Re:Could not add Second Deco at 1st floor
2021-01-13 22:18:36

@myroy 

 

If the Deco is turning red then the location where you would like it may be too far from the other Deco. If possible I would move it closer overhead where the first Deco is.

  0  
  0  
#2
Options