Seeking A Solution for an issue with the TL-WR802N

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Seeking A Solution for an issue with the TL-WR802N

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Seeking A Solution for an issue with the TL-WR802N
Seeking A Solution for an issue with the TL-WR802N
2022-01-27 06:19:10
Model: TL-WR802N  
Hardware Version:
Firmware Version:

Hello,

 

I have a TL-WR802N Nano router and it is connected wirelessly to my main router. I have a printer connected to the Nano via the Ethernet port and using a Wi-Fi capable laptop, I am able to access the printer's web interface with no issues.  However, I also have a desktop computer that is not Wi-Fi-capable that is connected to the main router via Ethernet port but I need it to be able to access the printer's web interface as well.

 

I have the main router's IP address, the Nano's IP address assigned to it by the main router, and also the Nano's default/built-in IP address.  Of course, this means that there are two networks.  What do I need to change to be able to access the printer's web interface from the desktop?

 

Thank you.

  0      
  0      
#1
Options
1 Reply
Re:Seeking A Solution for an issue with the TL-WR802N
2022-03-02 06:23:13

Hello @ODS29 

 

Please confirm what is the working mode of the WR802N? How did you connect it to the main router wirelessly? Is it Repeater mode?

 

What is the IP address and gateway on the desktop computer that is connected to the main router, and what is that on the printer? Be sure they are in the same network. You can try to do a simple ping test to see if they can see each other:

How to Use the Ping Command

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 720

Replies: 1

Related Articles