Hello all,

I realize this issue has been discussed in other threads, but none of the suggestions worked. I am looking for more ideas before I decide to move on from Deco, although I dread rebuilding my network. I just moved, and the decos worked at the previous residence.

Setup:

• Starlink Gen 3 (bypass mode)
• 3 Decos (XE75, Deco XE5300 (main), Deco S4)
• Wireless mesh works perfectly

Problem:

• The ethernet ports (besides the feed from the Starlink modem) are not working. Ethernet port (besides the feed from the Starlink modem) are not working. I need to connect an unmanaged switch.

Troubleshooting so far:

• I tried various ethernet cables.
• I connected to each available port on all three decos with no success.
• When I connect a Windows laptop, I look at the network status, which says "No Internet" and "invalid IP configuration."
• I connected directly to the Starlink modem to verify it's not giving out IP addresses (double NAT). It's in bypass mode and didn't provide an IP address to the laptop.
• I changed the IP addressing range to 192.168.69.50 - 192.168.71.250 
• Changed Primary DNS to 1.1.1.1 and secondary to 8.8.8.8

Current Settings:

• Operation mode: Wi-Fi Router
• No static routing
• IPTV/VLAN Disabled
• Mac Clone Disabled
• DDNS Disabled
• LAN IP: 192.168.68.1 Subnet Mask 255.255.252.0
• No Address Reservations
• No Port Forwarding
• SIP ALG enabled
• UPNP enabled
• Firmware up to date
• Automatic reboot at 3 am
• System time matches the phone
• QoS disabled
• IoT network disabled

I'm about to give up and go back to Google Wifi. 

Any troubleshooting tips are greatly appreciated!