Wifi setup after plugging into modem/ router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wifi setup after plugging into modem/ router
Model :
Hardware Version :
Firmware Version :
ISP :
I just set up my Archer C7. I am connected to CenturyLink DSL service (Phoenix, AZ) by plugging into a LAN port on my ZyXEL C1100Z modem/router. The only change I made in the setup for the C7 is I changed the IP address from 192.168.1.1 to 192.168.2.1.
My question is whether I should turn off the wireless radio on the C1100Z (since I am using the wireless on the Archer C7)? Everything is working fine without changing the settings on the C1100Z. Is there a downside to leaving both wireless radios on?
Thanks
Steve
Hardware Version :
Firmware Version :
ISP :
I just set up my Archer C7. I am connected to CenturyLink DSL service (Phoenix, AZ) by plugging into a LAN port on my ZyXEL C1100Z modem/router. The only change I made in the setup for the C7 is I changed the IP address from 192.168.1.1 to 192.168.2.1.
My question is whether I should turn off the wireless radio on the C1100Z (since I am using the wireless on the Archer C7)? Everything is working fine without changing the settings on the C1100Z. Is there a downside to leaving both wireless radios on?
Thanks
Steve
