Peter MLV4Offline
Following: 0Followers: 0
Forums/ Powerline Adapters
2018-10-22 15:56:21
Re:Setting up network address on Powerline 2000 how do you do it
PLC devices do not have network addresses, and they are not routers. They are equivalent to a network cable, no more no less.
0KUDOS
Forums/ Powerline Adapters
2018-10-17 14:53:15
Re:Pairing stops after a few minutes
When a PLC has nothing connected to its LAN port, it enters standby mode after a while. What exactly a "while" is depends on make and model.
0KUDOS
Forums/ Powerline Adapters
2018-10-15 16:56:46
Re:Trying to use 2000 adapters but not working
PLCs do not show up as regular network devices, for they do not occupy an IP address. They're fully transparent to that layer of networking. You need specific PLC software to see them.
0KUDOS
Forums/ Powerline Adapters
2018-09-03 16:40:51
Re:DHCP Error Message on Xbox and IP invalid error on Laptops
Make sure the four of them are actually all on the same powerline network, and also make sure your network uses your very own individual encryption passphrase. This is best done by plugging them all...
0KUDOS
Forums/ Powerline Adapters
2018-06-18 19:47:42
Re:TL-PA9020P Only 4 adapters
I know for a fact, from lots of experience in even the oldest of houses (100 years and up), that MIMO is never an issue, other than for DSL interference if the phone wire runs in the same tubes as...
0KUDOS
Forums/ Powerline Adapters
2018-06-15 15:42:12
Re:TL-PA9020P Only 4 adapters
See, that is exactly the kind of pointless and useless advice you keep getting here. Activating that feature cuts performance in half, for it disables MIMO. It will not resolve the five-units problem.
0KUDOS
123...11