Forums/
Deco
2024-10-04 12:17:18
NJRonbo wrote @NJRonbo So, basically, if I plug ethernet into two of the three deco units, they will automatically adjust the settings and all I need to do is use the app to put them in "bridge" or...
0HELPFULS
Forums/
Deco
2024-10-04 09:02:40
@Spandox You observe that on several meshes with several models of Deco? I would try setting up an IoT wifi network on the Deco, perhaps with only 2.4, or with reduced security, and connect the smart...
0HELPFULS
Forums/
Deco
2024-10-04 08:44:14
@NJRonbo Regarding backhaul. I take it there is a "bridge mode" or "AP" setting in the app that tells the two (of three) nodes they are connected? Do I have to designate a band I want the backhaul to...
0HELPFULS
Forums/
Deco
2024-10-04 08:32:01
@NJRonbo As you intend to connect two Deco by Ethernet to the ISP router, you must run the Deco mesh with an Operation Mode = Access Point. Indeed, when the Operation Mode = Router, one Ethernet port...
0HELPFULS
Forums/
Deco
2024-10-03 09:33:58
@rotodisc I do not believe those are actual "errors". There are routine events. . If you give the MAC and IP address of your hardwired computer, we could analyse the events related to it. . I am...
0HELPFULS
Forums/
Deco
2024-10-02 14:52:46
@Myscreenname123 The Deco app shows that a satellite Deco is connected by Ethernet to the main Deco, even if the satellite is connected by wifi to the main Deco? Does that persist when you unplug the...
0HELPFULS