Forums/
Deco
2024-01-08 06:37:41
@Briandpeterson The Operation Mode of the Deco network is under the "Advanced" setting. By default, it is "router". "TL-SG1005P has a wired IP camera that is working well": it is attached to which...
0HELPFULS
Forums/
Deco
2024-01-07 11:55:26
@Recycler29 The Deco can certainly act as a Router, this is its default (initial) behaviour. In some cases, it can even replace the ISP modem. From what I read in your message, I do not see any added...
1HELPFULS
Forums/
Deco
2024-01-07 11:44:34
@AggieAlum Each satellite Deco connects to only one other Deco, and the Deco are expected to be clever enough to make the optimal choice, and to adjust when needed. If the two P9 were connected...
0HELPFULS
Forums/
Deco
2024-01-07 11:25:40
@SeptemberC I assume your printer is connected to the Linksys router. I assume the Deco operation mode is "Router", the default. What are the local IP addresses of a device connected to the Deco and...
0HELPFULS
Forums/
Deco
2024-01-07 11:01:55
@Briandpeterson Is your Deco running in Router or Access Point mode? How is the main Deco connected to Internet? Did you try connecting another device to the TL-SG1005P, perhaps a laptop or another...
0HELPFULS
Forums/
Deco
2024-01-02 19:35:29
@ljCharlie I was wondering about that, and neglected to ask, because it would have been too obvious. Does that solve the issue?
0HELPFULS