HelpFixDecoAppLV4Online
Following: 0Followers: 2
Forums/ Deco
a week ago
Re:wired backhaul and yet LED shows RED
@zim2dive See if this helps What’s the difference between Access Point mode and Router mode on the Deco?
0HELPFULS
Forums/ Deco
a week ago
Re:No realistic way to change the Wi-Fi password on large Wi-Fi networks
@Crdrummer I think tp-link might be able to come up with some type of smart password protocol that would be supported by all there products where you could change the password on your deco or archer...
0HELPFULS
Forums/ Deco
a week ago
Re:wired backhaul and yet LED shows RED
@zim2dive Since the 3rd unit is the one going red I would first try to replace the cable that goes from the switch to the 3rd unit. You could also try going from a different port on the switch to the...
0HELPFULS
Forums/ Deco
a week ago
Re:Feature Request - Better signal strength info
@Larry-R Thank you for the suggestion. I recommend you also post it here. Suggestions for new options tend to get lost in the forums.
1HELPFULS
Forums/ Deco
a week ago
Re:network device has joined the network
@bchelbig Network device is just the generic name for one of your devices. While your in the Offline client list you can pick one of the devices and write down the mac address then click on it you...
0HELPFULS
Forums/ Deco
a week ago
Re:Two X50 Outdoor Units show as Daisy Chained in app but Arent? latest FW
@Robotica72 This is an issue with the X50 outdoor firmware I recommend sending an email to forumsupport.usa@tp-link.com with the following information: Subject: [Forum Escalation][ID 840520] Two X50...
0HELPFULS
1234...