I've been trying for some time to get the Archer A7 to run at gigabit speeds. So far, I've found that the speed when IPv6 is enabled maxes out at less than about 400 mbits. With IPV6 off, and NAT...

@livewirefilms NAT Boost is at Advanced:System Tools:System Parameters. About 3/4 of the way down is NAT.

@dmitch. What speed are you trying to get? I'll be very curious to see if your results are the same as what I've seen. I did hear from TP-Link on this topic and they've told me that IPv4 has hardware...

@StevenRN I was experiencing slow wan to lan throughput with the Archer A7 after I upgraded my comcast service to gigabit. my typical throughtput was about 300 Mbits. I'd been round and round with...

@Vittorio71 When you say the provider, I assume you mean the ISP. In this case, I can get near gigabit speeds when I connect directly to the modem (800+ Mbits). But when I connect through the A7...

@StevenRN StevenRN wrote @t.l Hi Bud, I don't know if this might help, but I wrestled with this for over a week on an Archer C8, maybe it applies to the Archer C7. New 500/50 service, and no matter...