TP link AC 1200 not getting full ethernet speeds

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP link AC 1200 not getting full ethernet speeds

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

csfeist

2019-06-25 19:54:45

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-06-25

TP link AC 1200 not getting full ethernet speeds

2019-06-25 19:54:45

Model: Archer C1200

Hardware Version: V3

Firmware Version: 3.04 Build 20180122

I have a TP Link AC 1200 wife dual band modem and I just upgraded to Spectrum's gig service. When I connect my cat6 ethernet directly to the modem I am getting the full 940Mbps speeds they say you get. When I connect it into the ethernet ports on the back of the router which are supposed to handle gig speeds I'm only getting around 500-550 down speeds. The upload speeds are just fine.

QoS is turned off

NAT Boost is on

Is there any other settings somewhere I should be looking for or is my router possibly have bad ethernet ports?

Thanks

Chris

1 Reply

matmatician

LV1

2019-06-26 16:02:22

Posts: 8

Helpful: 16

Solutions: 0

Stories: 0

Registered: 2019-05-27

Re:TP link AC 1200 not getting full ethernet speeds

2019-06-26 16:02:22

I'm seeing similar issues on wired. Makes no sense if your AP is in bridged mode and the router is handling all the routing. Have you checked your router settings to see if maybe there's something in there that can be tweaked to increase the priority on the ethernet port your AC1200 is plugged into?

TP link AC 1200 not getting full ethernet speeds

TP link AC 1200 not getting full ethernet speeds

Information

Voters 0

Tags