Trouble accessing Router set up as WAP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Trouble accessing Router set up as WAP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Trouble accessing Router set up as WAP
Trouble accessing Router set up as WAP
2020-07-14 18:55:49
Model: Archer C7  
Hardware Version:
Firmware Version:

My set up is as follows:

Router 1 (Linksys E200), WiFi disabled (3 computers + Router 2). WAN input from Verizon 192.168.1.1. DHCP range 10-59

Router 2 (Archer C7), WiFi.  PC + Phone on LAN ports. Connected to Router 1 via LAN port. LAN IP 192.168.1.2 DHCP disabled

 

I can only access the C7 Web setup page if I change the setup so that it connects to Router 1 via the WAAN port (but that causes me to lose interconnectivity between computers on the network). It is not visible on the Windows Network in Explorer (Router 1 is visible).

 

Everything works, I just can't get tothe set up page routinely. SInce I don't need to, it is not a big deal but I think I should be able to see it (?)

 

Thanks. 

  0      
  0      
#1
Options
1 Reply
Re:Trouble accessing Router set up as WAP
2020-07-15 17:19:45

@M_Rogovin 

 

Go to Advanced > System Tools > Administration, and make sure local management is enabled.

  0  
  0  
#2
Options