HS 200 - ceiling fan/light

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

HS 200 - ceiling fan/light

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
HS 200 - ceiling fan/light
HS 200 - ceiling fan/light
2020-08-25 02:25:34
Model: HS200  
Hardware Version:
Firmware Version:

I am not fully sure of how to explain my question. 

 

I have installed my hs200 with the specifications outlined. The only difference from the switch I took out is the addition of a neutral jumper to the switch. Prior to installing the hs200 the fan would run without the switch being on. Now the fan seems to be dependent on the switch. Is there a reason for this? Can I set this up so that the fan can remain on while I control just the light with the switch?

  0      
  0      
#1
Options
2 Reply
Re:HS 200 - ceiling fan/light
2020-12-21 19:37:47
The only way I can see you having the fan work all the time is having a direct hot that bypasses the switch or a second switch for the fan. My fan/lights are controlled with 2 switches so I can have either on at all times.
  0  
  0  
#2
Options
Re:HS 200 - ceiling fan/light
2020-12-22 02:42:12

@Pbaker did the original switch have 2 wires to one screw, and one wire on the other screw?

  0  
  0  
#3
Options