D225 Doorbell Issue
I recently installed my new Tapo D225 doorbell and hardwired it to my existing doorbell wiring but it does not seem to be charging. I checked the voltage on the wires feeding the doorbell and it is reading 18V. Any assistance would be greatly appreciated. Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@NCSU86 Did you install the jumper into your chime? I am looking into purchasing the doorbell and notice this was a step during installation. Otherwise- how are you like the doorbell?
- Copy Link
- Report Inappropriate Content
@NCSU86 I did not install the jumper wire as I am not using the "always on" feature. I am currently fully charger the battery and will reinstalled with it hardwired to see if that helps. May try the jumper option if it continues not to work.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@NCSU86 ,I installed yesterday it was charging with green icon to 100 ,woke up morning ,charging disappeared and now at 99percent. Is this normal ,also how to bypass existing chime with provided jumper cable .
- Copy Link
- Report Inappropriate Content
Same issue , will not ring old chime, just installed.
Replaced ring camera which was using power device to detect voltage change to and activate chime.
Seems that some thing is not designed to create short time signal to chime like contact short
Please provide solution for old chime.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 512
Replies: 5
Voters 0
No one has voted for it yet.