Kasa ES20Ms Hangs every few days and requires a reset
I owned 2 Kasa ES20Ms. Every fews days, they hang and I need to push the reboot button for them to start working again.
Wondering if other folks are facing the same issue and what TP-Link is doing about it since this has been happening for several months now.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@epiphanyplx , still an issue with firmware 1.1.6 and using latest HA.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@optmode That makes sense, seems in-line with the behavior I see where it takes some time to go non-responsive.
I disconnected one of my two from Home Assistant and the issue persisted so I guess it's not related. I didn't have the issue until I added a second ES20M to my house. Does anyone have the issue with just a single ES20M?
- Copy Link
- Report Inappropriate Content
Is your switch's firmware updated? The latest version for ES20M V1.0 is 1.1.6 Build 250522 Rel.210254.
If the issue persists with the latest firmware (and without using Home Assistant or other open‑source platforms), please reach out to the support team for further investigation. Contact Technical Support
- Copy Link
- Report Inappropriate Content
@Wayne-TP Yes, firmware is fully updated.
Support said that one of my units was too old for RMA and offered no other resolution.
- Copy Link
- Report Inappropriate Content
Saw this post on reddit the other day:
https://www.reddit.com/r/homeassistant/comments/1qan7ki/comment/nzb7abd/?context=1
I have disabled polling in home assistant for my 2x ES20Ms, will see if it resolves.
- Copy Link
- Report Inappropriate Content
@epiphanyplx did disabling polling work for you?
epiphanyplx wrote
Saw this post on reddit the other day:
https://www.reddit.com/r/homeassistant/comments/1qan7ki/comment/nzb7abd/?context=1
I have disabled polling in home assistant for my 2x ES20Ms, will see if it resolves.
- Copy Link
- Report Inappropriate Content
@rg60614 yes it fixed the problem, still it is a memory leak issue that TP-Link should fix but till then this is a good work around
- Copy Link
- Report Inappropriate Content
@rg60614 yep! Finally able to put the light switch cover back on...
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2098
Replies: 29
Voters 0
No one has voted for it yet.