Tapo Smart Switches
Transform your traditional light switches into smart lights with Tapo Smart Switches! Control your lights with your voice, remotely manage your power usage, and create automation scenes for ultimate convenience. This forum section is your resource for installation guides, compatibility questions, and discussions about getting the most out of your Tapo Smart Switches.
Tapo Smart Switches
The apartment I just moved into has a hallway light with a switch at each end of the hallway. Not sure what they were thinking when they wired it, but they used two 2-way SPST light switches in series
Wiring & InstallationConfiguration Guides and TipsAutomations
0Helpful
74Views
If you manually press the button to turn the light on, will it remain on until you press it again, or will it automatically turn off based on the motion settings? Ideally I would like for this switch
1Helpful
49Views
Has anyone else had trouble with 2 step verification sending email that takes too long to receive and the app verification screen times out? I understand I can turn off two step verification once I ge
0Helpful
200Views
Will matter support be added to any of your speciality switches? I'd love to see a 3-way for the hallways and motion sensor dimmer switch for the bathrooms. Also a matter switch that didn't require a
Matter Protocol
2Helpful
419Views
is there any update for a new product for at least a 4-way dimmer switch? The 3-way works great; however, I had to remove the 4-way switch from my setup and replace with a blank switch cover.
0Helpful
91Views
The Tapo app appears to be missing a required feature for Matter multi-admin. I purchased Tapo S505 switches and added them to Matter using the Tapo app as recommended (rather than a 3rd party). Now I
Matter ProtocolConfiguration Guides and Tips
0Helpful
191Views
I want to dim my lights if it is left on after certain period, but I cannot figure out with Tapo automation. I have S505D Dimmer switches. 1. If the light is left on for 30 minutes, 2. Dim it to 50% o
By
EggheadCaptain
· Latest post 2024-10-27 15:03:46
by RyanEverhart789
1Helpful
94Views
1. Is there a command option available on the smart switches that will allow one to FLASH the lights? I want to be able to put the switch into an "ALARM" mode, whereby I can tell the switch to flash (
By
stuntflyer
0Helpful
78Views
My house was built in the 1930s and does not have a neutral or ground wire for light switches. Can I use the S500 or S500D with no ground wire?
Wiring & InstallationConfiguration Guides and Tips
0Helpful
192Views
I have a KS200MP2 switch that I'd like to use to control what I think is a 3-way configuration. There are two switches that control the same light at the top of the stairs. When I connect it, the swit
Wiring & InstallationConfiguration Guides and Tips
By
gossamer
0Helpful
105Views