Smart Home Community > Tapo Smart Plugs > Adding P306 to Tapo App after adding to HomeKit
< Tapo Smart Plugs

Adding P306 to Tapo App after adding to HomeKit

Adding P306 to Tapo App after adding to HomeKit

Adding P306 to Tapo App after adding to HomeKit
Adding P306 to Tapo App after adding to HomeKit
a week ago
Tags: #Setup and Configuration
Model: Tapo P306  
Hardware Version:
Firmware Version:

I have four of these and I guess I added at least one to HomeKit before I added it to the Tapo App. Because three of them are in the Tapo app and one is not.

 

Is there any way to add it to the Tapo App without factory resetting it and remove it from HomeKit?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Adding P306 to Tapo App after adding to HomeKit
Tuesday

  @PhreakStorm 

 

If you try to add it to the Tapo app and it wont add you may have to reset it. You might be able to get away with keeping it in HomeKit after you reset it but not sure.

 

When you try to add it in the Tapo app is the app just not finding it? Are you getting any errors in the Tapo app when you try to add it? 

Need help with the Deco app, setup, Ethernet backhaul, network switch or rolling back firmware? Router or AP mode? https://community.tp-link.com/us/home/forum/topic/699816?page=1
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 82

Replies: 1

Tags

Setup and Configuration
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.