HS220 loses WiFi and turns lights on

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

HS220 loses WiFi and turns lights on

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
HS220 loses WiFi and turns lights on
HS220 loses WiFi and turns lights on
2020-07-07 15:08:43

I installed a HS220 about 6 months (or so) ago and everything worked great.  Yesterday I woke up and the lights controlled by the switch were on and the wifi was lost.  I would turn the lights off but after a short time (10 -15 minutes) they would come back on.  I reset the switch connected it to my wifi, Kasa again and updated the FW.  everything worked great.  This morning I come down and the same thing has happened.  Lights on and lost WiFi.  The WiFi symbol on the front of the switch is red.  AFter a short time it goes to flashing green and orange for a short time then back to red.  Is the switch bad?  Any ideas?

  0      
  0      
#1
Options
2 Reply
Re:HS220 loses WiFi and turns lights on
2020-07-08 18:15:59

@SD-Rick 

 

The red LED indicates that it does not have a Wi-Fi connection. If it goes amber then amber and green it may be rebooting? If the device reboots then it would be set to the on state.

 

You can look to move it to another outlet preferably closer to the router to see if the issue follows the switch or stay at the outlet being used. 

 

At that point, I would probably reach out to support.

  0  
  0  
#2
Options
Re:HS220 loses WiFi and turns lights on
2020-07-08 22:20:39

@SD-Rick  Tony,

Thank you for responding so quickly!  This is a single pole, dimmer switch that I purchased 12/12/2019 from Costco.  The switch that is being used is one of 14 switches I have installed in my house.  Some are closer to the router and some are further.  This switch worked perfectly until the other night when it would not turn off the lights.  It can find the wifi (which is about 15 to 20 feet away) and connect again but it loses the connection and blinks orange and green or holds a red, it switches between the two.  All of my other switches work fine.  I updated the FW on Monday afternoon to the latest version.  

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 979

Replies: 2

Related Articles