Forums/
Deco
2 weeks ago
@HelpFixDecoApp Just enabled it. So far the only thing I see is the ability to enable Client Identification (which I may leave disabled since I have all my devices configured accordingly). Is there...
0HELPFULS
Forums/
Deco
2 weeks ago
I actually might be limited to the type of settings that are available since my network is currently configured in AP mode.
0HELPFULS
Forums/
Deco
2 weeks ago
@HelpFixDecoApp ended up downloading/installing the firmware. One thing I noticed right away (at least via the Web portal) is that I can see the CPU/Memory usage of the network. Going to check the...
0HELPFULS
Forums/
Deco
2 weeks ago
@HelpFixDecoApp would it be worth downloading the beta for the Deco XE75Pro (V2) units and keeping the X50-Outdoor (V1) on the stable firmware?
0HELPFULS
Forums/
Deco
2 weeks ago
In terms of the overlapping channels I mentioned, two units were on overlapping channels vs. one being on a non-overlapping channel (one of the units on the overlapping channels were set to 40MHz...
0HELPFULS
Forums/
Deco
2 weeks ago
Hey @Ryan, I was reaching out to see if there was any beta firmware for both of these Deco units (US models by the way) that will allow me to change the channel width for the 2.4GHz band. I did try a...
0HELPFULS