Forums/
Access Points
2020-12-01 23:43:19
@Super7 If you want one network to connect then, then yes you would set them all to the same SSID. The roaming aspect will depend on your device itself so you may not get the desired results. I would...
0HELPFULS
Forums/
Kasa Smart Switches
2020-12-01 23:40:28
@Rlawlyes1 You can install one HS210 for each three-way circuit, but since you have three you can get two HS210 kits and use two HS210s for one of the three-way circuits. The dimmer switches would be...
0HELPFULS
Forums/
Deco
2020-12-01 23:12:53
@dpharshman Here is a FAQ that shows software-wise the differences: https://www.tp-link.com/us/support/faq/2399 As far as hardware, in AP you can wire all nodes directly to the original router, in...
0HELPFULS
Forums/
Kasa Smart Switches
2020-12-01 22:49:59
@GatorBlair If installing the HS210 by itself it is recommended to have it installed on the live side, which seems like the dumb switch is on. Since the HS210 needs to be on the load side, you would...
0HELPFULS
Forums/
Deco
2020-12-01 22:21:46
@radcapitalist The type of connection the Deco has and the hops the device needs to jump affects the speeds. The easiest way to help with speeds at first would be to move the Deco units to a...
0HELPFULS
Forums/
Kasa Smart Bulbs
2020-12-01 21:53:15
@Andrew93 Enable the guest network on your Deco network, and only enable the 2.4G, now reset both bulbs (off and on five times), and connect them to that guest network. If that works, you can leave...
0HELPFULS