Pharos Wireless Bridges

TP-Link Pharos Outdoor CPEs are dedicated to Point-to-(Multi)Point transmission, ideal for short-to-medium range wireless communication among two or more locations. Anything related to Pharos Outdoor CPEs, welcome to ask questions, join discussions and share your experience/knowledge here.
Pharos Wireless Bridges

Tags

Label

 
Hello Gentlemen I have cpe 510, the signal is ok, and connections is ok, and the IP’s is ok, but when I ping the second cpe 510, every 5 min I have 4 request timeouts. Plz advice Nice Regards Wisam
By switch_Lines · Latest post 2021-01-15 02:46:33 by Fae
0Helpful
631Views
1Replies
We are still unable to get 2 antennas to connect and we recently looked at altitude survey between the 2 locations and we noticed the one is +-30m higher and seperated by 4km. Do the antennas need to
By ClintonBrits · Latest post 2021-01-15 02:36:02 by Fae
0Helpful
362Views
1Replies
Trying to get Ethernet to go from a barn, which was the only serviceable place, to a house. Bought two CPE210 to try this. ----modem .1 ----CPE210 in AP mode .55 )))))(((((( CPE210 in client mode .54
By kingofpikachus · Latest post 2021-01-13 21:45:44 by kingofpikachus
5Helpful
1212Views
2Replies
Hi. I have just ordered one cpe210 to extend WiFi down a long garden to my office. My question is, do I have to have a server running all the time? If yes, will Pharos for Linux run on a raspberry pi
By Dave_Les_Well · Latest post 2021-01-11 09:37:13 by Pawel_T
0Helpful
960Views
2Replies
I have an existent DSL internet connection using rebranded DSL modem/router with wireless from ISP. This alone works OK, all phones and computers in the house can connect to the router wifi. Router ha
By adrianTNT · Latest post 2021-01-04 10:54:25 by Fae
0Helpful
2507Views
3Replies
Hi. I'm new to this with radio link. I have two cpe210s. one set AP and one as client. it works as it should. I have some thoughts / problems Problem 1 I lose my wifi here at home all the time. if I t
By pberntzen · Latest post 2020-12-29 08:26:17 by Fae
0Helpful
437Views
1Replies
I am planning to setup a Point to Point connection to get internet to a remote location. One CPE510 will be configured as AP. My doubt is the second CPE510 at the remote location... what advantages /
By Ulf01 · Latest post 2020-12-29 08:04:29 by Fae
0Helpful
381Views
1Replies
Hi, I would like to know that is there any product available for transmitting the WiFi signal to long-range covering the area 15Km with 180° of a wide range. So my case is I want to have a sender whic
By Gowthamaraja · Latest post 2020-12-24 12:08:13 by Fae
0Helpful
361Views
1Replies
I'm wasting so much time because after setting up a cpe210 as client I cannot consistently connect to it. sometimes browser timeouts, sometimes the Pharos interface, and sometimes if fails as I poke a
By JennyCouncil · Latest post 2020-12-24 11:24:13 by Fae
0Helpful
576Views
2Replies
Hi, I’m troubleshooting a slow connection with CPE210 My setup is the following: Home #1 router > CPE set as AP > CPE set as Client > Home #2 router. Speed on the #1 router is up to 344 Mbps download,
By cwestg20 · Latest post 2020-12-24 11:10:58 by Fae
0Helpful
1262Views
2Replies
1636465...
1636465...