I am desperate - OC200 connection problem
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm literally desperate!
Every 5/10 minutes my WiFi connection get lost
no error on the oc200, no reset happens, nothing visible
Phone, pc , tv, everything get disconnected (no WiFi signal) and after 10/20 seconds get connected back.
other things that happen: WiFi remain (full power) but I don't have connection (it isn't a provider problem), I can even reach the controller via 192.168.0.2
Oc200 is new! I tried to buy a new one but nothing changed. The first one I've bought about 3 years ago, never had a problem until 2 months ago (I changed nothing on my system)
OC200
router ER605
eap110 indoor (7pc.)
eap110 outdoor (3pc.)
2 ssid setted on the network
please, PLEASE PLEASE help me
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Tedd404 yes and I tried
ping is perfect, when I get the problem I can't ping the ip and after few seconds everything starts working again
- Copy Link
- Report Inappropriate Content
if this is the case, you should check if you get an IP address when this happens. does it turn to 169.254.x.x at that point? if yes, then you should check the cable.
or the router is the issue.
if you believe this is a hardware issue with the eap110-outdoor, buy a new device and try it out.
my guess is still the hardware in your environment. rare to have a bad AP.
eap110 is the 2.4g eap, which is easily being interfered with. bear this in mind, you should reduce the interference. analyze your network by free software.
- Copy Link
- Report Inappropriate Content
In Post 18 I asked you to try with the SWITCH removed from your configuration, yet in 19 you did everything but.
I think KyrieM (post 2) may have been correct, it sounds like there is some kind of loop on a wifi device that is causing the switch port to shutdown temporarily to quell the storm caused by a loop.
- Copy Link
- Report Inappropriate Content
@d0ugmac1 I tried to remove the switch but I had ping problem about 700/800ms
so I had to insert switch again.
how can I check if there are some loops?
thanks
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Ivanx00 As someone already mentioned you may be having interference problems and I'm chiming in here with a question about how you have planned your WiFi radio network? Meaning what channels do you use?
Although things seem to have been working fine before, perhaps you made some changes in this area at the time of upgrading to 5.12.9??
Try setting your channels so that nearby APs don't overlap and remember that on 2.4Ghz, channels are wider than the numbers suggest. So channel 6 interferes with channels 4, 5, 7 and 8. So channels 1, 6 and 11 on three neighboring AP's is safe, and anything else provides some risk of interference.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2507
Replies: 26
Voters 0
No one has voted for it yet.