Omada Captive Portal not showing if ACL are enabled

Omada Captive Portal not showing if ACL are enabled

Omada Captive Portal not showing if ACL are enabled
Omada Captive Portal not showing if ACL are enabled
Friday - last edited Yesterday
Model: OC200  
Hardware Version: V1
Firmware Version: 1.31.3 Build 20240620 Rel.80383

Hi, 

I have a short stack setup on my home network composed of OC200, ER605, SG2008P, and EAP650. After double-checking the configuration, I found some issues in the Captive portal. When my Kids' SSID is added to ACL Rules and the rules are Deny access Source; Kids SSID and Destination; Default Lan, the kids' captive portal won't show or load, but when I disabled the ACL rules, the captive portal loads normally. I made the ACL rules so my kid's LAN can't ping or access the Default or Main LAN. 

 

I created a duplicate configuration of Lan and Vlans (ex. Lan1 & Lan2) the only difference between the two is that Lan1 has ACL Rules and Lan2 doesn't have ACL Rules. The Lan1 doesn't show or load his captive portal but the Lan2 shows his captive portal. 

 

Each Lan has its own Lan and SSID and Vlans and Captive portal the only difference in their configuration is the ACL Rules.

 

regards,

  0      
  0      
#1
Options
2 Accepted Solutions
Re:Omada Captive Portal not showing if ACL are enabled-Solution
Friday - last edited 22 hours ago

  @AkoNaNi 

 

You need to make an allow rule using IP groups from kids SSID > Controller IP on main LAN, and place it above the deny rule.

Recommended Solution
  1  
  1  
#2
Options
Re:Omada Captive Portal not showing if ACL are enabled-Solution
Yesterday - last edited Yesterday

Hi  @AkoNaNi 

 

As GRL said, you need to create an allow ACL.

This is because the portal configuration requires continuous communication with the controller to maintain proper operation.

Recommended Solution
  0  
  0  
#3
Options
4 Reply
Re:Omada Captive Portal not showing if ACL are enabled-Solution
Friday - last edited 22 hours ago

  @AkoNaNi 

 

You need to make an allow rule using IP groups from kids SSID > Controller IP on main LAN, and place it above the deny rule.

Recommended Solution
  1  
  1  
#2
Options
Re:Omada Captive Portal not showing if ACL are enabled-Solution
Yesterday - last edited Yesterday

Hi  @AkoNaNi 

 

As GRL said, you need to create an allow ACL.

This is because the portal configuration requires continuous communication with the controller to maintain proper operation.

Recommended Solution
  0  
  0  
#3
Options
Re:Omada Captive Portal not showing if ACL are enabled
22 hours ago - last edited 22 hours ago

  @GRL it works, I put the Permit ACL to the top 1st and the Deny ACL to 2nd, and now it works. Big Thanks :)

  0  
  0  
#4
Options
Re:Omada Captive Portal not showing if ACL are enabled
22 hours ago

  @Vincent-TP Yes, and it works now. Big Thanks

  1  
  1  
#5
Options