Business Community > Gateways > Customize Loopback Interface on Omada VPN routers (Standalone & Cloud)
< Gateways

Customize Loopback Interface on Omada VPN routers (Standalone & Cloud)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Customize Loopback Interface on Omada VPN routers (Standalone & Cloud)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Customize Loopback Interface on Omada VPN routers (Standalone & Cloud)
Customize Loopback Interface on Omada VPN routers (Standalone & Cloud)
2025-01-06 02:54:00 - last edited 2025-01-07 02:08:04
Tags: #Routing #NAT #VLAN & Multi-Networks #WAN Setup
Model: ER706W  
Hardware Version: V1
Firmware Version: 1.1.2

Hi, as stated in the title, I can't find anywhere to setup lookback interface in standalone/cloud GUI in Omada VPN Routers. Under 'Wired/Wireless Networks>LAN", when I try to create a new lan, i can't put the ip that I want to be a customize loopback ip. For example, 1.2.3.4/255.255.255.255.

 

On Omada Switch, I can easily create one under "L3 Features>Interface>Add>Interface ID:Loopback"

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Customize Loopback Interface on Omada VPN routers (Standalone & Cloud)-Solution
2025-01-07 02:07:48 - last edited 2025-01-07 02:08:28

Hi @ChanKF 

Thanks for posting in our business forum.

I am not sure what you are referring to but this device does not support manual configuration of the NAT loopback if you are referring loopback to the NAT loopback.

Our routers support NAT loopback and enabled by default. No configuration is required.

Recommended Solution
  1  
  1  
#3
Options
2 Reply
Re:Customize Loopback Interface on Omada VPN routers (Standalone & Cloud)
2025-01-06 03:38:24

In Switch Cli Command, a successful configuration of customize loopback interface will be " interface loopback x (id) ", then followed by " ip address 1.2.3.4 255.255.255.255 ";

 

In VPN Router Cli Command, there's only " interface (vlan/switchport) ", no loopback options.

  0  
  0  
#2
Options
Re:Customize Loopback Interface on Omada VPN routers (Standalone & Cloud)-Solution
2025-01-07 02:07:48 - last edited 2025-01-07 02:08:28

Hi @ChanKF 

Thanks for posting in our business forum.

I am not sure what you are referring to but this device does not support manual configuration of the NAT loopback if you are referring loopback to the NAT loopback.

Our routers support NAT loopback and enabled by default. No configuration is required.

Recommended Solution
  1  
  1  
#3
Options

Information

Helpful: 0

Views: 599

Replies: 2

Tags

Routing NAT VLAN & Multi-Networks WAN Setup
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.