TP-Link CommunityTapo Smart HubH200 Hub Solid red LED, doesn't respond to reset
Tapo Smart Hub

H200 Hub Solid red LED, doesn't respond to reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

H200 Hub Solid red LED, doesn't respond to reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
H200 Hub Solid red LED, doesn't respond to reset
H200 Hub Solid red LED, doesn't respond to reset
2025-02-24 22:41:56 - last edited 2025-03-11 08:17:20
Model: Tapo H200  
Hardware Version:
Firmware Version:

The H200 isn't responding to reset orders, the LED stays Solid red. I have tried various ways of resetting the device. I have tried with and without SD card. I have used various cables, connected it directly to the router and tried via a network switch.

 

Is there any way to fix this issue?

0
0
#1
1 Accepted Solution
Re:H200 Hub Solid red LED, doesn't respond to reset -Solution
2025-02-27 03:19:49 - last edited 2025-03-11 08:17:20

  @Thimo161 

 

  • Disconnect the hub from power for a while, like 20-30mins.
  • Remove SD card and the ethernet cable.
  • Power up the smart hub and wait for 1-2 mins.
  • Reset the smart hub: use a pin to press the reset button - press and hold for about 5-10s. Monitor whether the led indicator shows any changes.

 

If the led indicator still shows no changes, you may contact the retailer or local TP-Link support to proceed warranty for this device. 

▶ CES 2026 Meet TP-Link AI Assistant and More New Products!
Recommended Solution
0
0
#2
1 Reply
Re:H200 Hub Solid red LED, doesn't respond to reset -Solution
2025-02-27 03:19:49 - last edited 2025-03-11 08:17:20

  @Thimo161 

 

  • Disconnect the hub from power for a while, like 20-30mins.
  • Remove SD card and the ethernet cable.
  • Power up the smart hub and wait for 1-2 mins.
  • Reset the smart hub: use a pin to press the reset button - press and hold for about 5-10s. Monitor whether the led indicator shows any changes.

 

If the led indicator still shows no changes, you may contact the retailer or local TP-Link support to proceed warranty for this device. 

▶ CES 2026 Meet TP-Link AI Assistant and More New Products!
Recommended Solution
0
0
#2

Information

Helpful: 0

Views: 667

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.