Home Network Community > Deco > Setting up the X10 as wireless bridge
< Deco

Setting up the X10 as wireless bridge

Setting up the X10 as wireless bridge

Setting up the X10 as wireless bridge
Setting up the X10 as wireless bridge
a week ago - last edited a week ago
Tags: #Network Connectivity #Deco Ethernet Backhaul #Connection Preference #Installation
Model: Deco X10  
Hardware Version: V20
Firmware Version: 1.0.6

Hi!

 

Is it possible to use the X10 as a wireless bridge and connect a switch to the Ethernet ports on the satellites?

Would make it a lot easier to get cables to all floors. 

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Setting up the X10 as wireless bridge-Solution
a week ago - last edited a week ago

  @bjosom You can connect Deco X10 Main Unit with your ISP router / modem and do the setup from Deco App and then you can connect Satellite Deco nodes over WiFi without any wire.

Please & Thank You !! ❤️
Recommended Solution
  1  
  1  
#2
Options
1 Reply
Re:Setting up the X10 as wireless bridge-Solution
a week ago - last edited a week ago

  @bjosom You can connect Deco X10 Main Unit with your ISP router / modem and do the setup from Deco App and then you can connect Satellite Deco nodes over WiFi without any wire.

Please & Thank You !! ❤️
Recommended Solution
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 68

Replies: 1

Tags

Network Connectivity Deco Ethernet Backhaul Connection Preference Installation
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.