Omada hardware controller (OC200) does not show any clients connected to EAP-245

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada hardware controller (OC200) does not show any clients connected to EAP-245

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada hardware controller (OC200) does not show any clients connected to EAP-245
Omada hardware controller (OC200) does not show any clients connected to EAP-245
2021-10-08 02:01:32
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.0.3 Build 20210604 Rel. 51934

I have few EAP 245 newly connected to OC200, before buying hardware controller EAPs were managed localy via their web server. I wanted to extend the possibilities with buying hardware controller, when I adopted devices (EAPs) it showed me to upgrade the EAPs firmware which I have done:

EAP Firmware: 5.0.3 Build 20210604 Rel. 51934

 

Adaptation has succeed but I can not see any clients or statistis, even if clients are connected (I am sure) to certain EAP (tested and verified).

 

Why after adding controller to the setup I can not see clients anymore.... I know there was simillar topic but for software (Windows) controller?

 

My OC200 setup:

 

Model: OC200 1.0

Controller Version: 4.2.11

Firmware Version: 1.7.4 Build 20210118 Rel.72627

 

Should I updgrade/downgrade some firmware, if so which versios are compliant?

  0      
  0      
#1
Options
1 Reply
Re:Omada hardware controller (OC200) does not show any clients connected to EAP-245
2021-10-08 09:48:12

Dear @Kostek,

 

Kostek wrote

I have few EAP 245 newly connected to OC200, before buying hardware controller EAPs were managed localy via their web server. I wanted to extend the possibilities with buying hardware controller, when I adopted devices (EAPs) it showed me to upgrade the EAPs firmware which I have done:

EAP Firmware: 5.0.3 Build 20210604 Rel. 51934

 

Adaptation has succeed but I can not see any clients or statistis, even if clients are connected (I am sure) to certain EAP (tested and verified).

 

Why after adding controller to the setup I can not see clients anymore.... I know there was simillar topic but for software (Windows) controller?

 

My OC200 setup:

 

Model: OC200 1.0

Controller Version: 4.2.11

Firmware Version: 1.7.4 Build 20210118 Rel.72627

 

Should I updgrade/downgrade some firmware, if so which versios are compliant?

 

Please double-check the current firmware version of your OC200 under Settings -> Maintenance.

 

If its controller version is still 4.2.11, please upgrade the controller to the latest firmware 1.9.1 for checking.

Omada Hardware Controller v4.4.4 has been released by September 16, 2021

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options