Trouble setting up SG3210X-M2 switch
I'm having trouble setting up my switch and getting it to connect to my software controller.
My network is at 10.6.1.0/24 but the switch turns on with the IP 192.168.0.1
I was very surprised because the switch is configured to use DHCP:
I tried adopting it into my software controller anyway, but it failed:
Then i tried setting a static IP and adopting again. It progressed further:
But it ultimately failed, and if you look closely, the adoption process changed its IP back to 192.168.0.1
These are the errors that I can see on the software controller:
But I'm not sure how to proceed from here.
PS - It also occurred to me that my network configurations could be wrong, but they seem right to me:
What could I try to fix this? What settings might be wrong?
Meaning this is the default VLAN 1?
If so, the switch does not get the IP address, which means there is a connection problem. There is no link to the DHCP server, so the switch cannot get a DHCP IP.
When the controller adopts a switch, it is by necessity factory reset during the adoption process, and unless you add the switch and preconfigure it in omada (using the device key) the adoption will set it back to DHCP . Everything points to your DHCP server being unable to assign an IP to the switch so the switch is using its fallback IP (192.168.0.1) which it does when it cant get an IP from DHCP - at which point the adoption will fail.
You can get this to work however without doing a device key based preconfig - reset the switch. attempt adoption. It will probably fail, but you now have it in a "disconnected" state in the controller but this will still allow you to configure its entry to a static IP (click on the switch, config, vlan interface, configure the default vlan interface and set its static IP in here)
Disconnect and factory reset the switch, manually log into it and set its static IP in the standalone GUI as you were before, and save the config in the GUI. Now, connect it and adopt it again. It will now be adopted with the static IP you set earlier and should now succeed.
